Designed to stick two surfaces together without being seen, these versatile tapes deliver neater-looking projects and better craftsmanship. And unlike screws or rivets – which join materials at a single point – high-strength double-sided tape permanently adheres one substrate to another while spreading the stress load. I plan to either just bend it, or cut it and re-crimp the end.Double-sided tape is any tape that is coated with adhesive on both sides. I realized the bazooka filter is too long. If all is well, add on the bazooka filter and make some wort.To save water and time, I used 2 5-gallon buckets and re-used my test water over and over. Tighten up the ball valve and do a leak test.On the outside of the cooler, slide a metal washer onto the fitting (should already have teflon on it) and then screw on the ball valve.Make sure that the white rubber washer that came with the cooler fits in the same way that you got it, to ensure a seal (see first pic below) Slide the entire piece into the cooler hole, from the inside, with the newly wrapped/untouched side first.Wrap the untouched end of the fitting with teflon tape, in preparation for the ball valve.Make sure it's sitting perfectly flat against the metal washer. Put on the white rubber fitting that came with the cooler so the flat side is up against the washer that is up against the hex of the fitting (the white rubber fitting is pretty much sitting on the hex of the fitting).(there should already be teflon tape on the threads) Screw on the fitting that came with your bazooka filter, and tighten it down good.Screw on the the nut that comes with the ball valve and tighten it as much as you can but don't go crazy because you don't want to destroy the rubber washer.Try to avoid disturbing the teflon tape that was just added. Put on one of the rubber washers that come with the ball valve and snug it up against the metal washer.Focus in making a seal where the washer meets the fitting. I put the teflon tape on pretty heavy (maybe 3-4 wraps) all the way down to the end of the threads. Next, use teflon tape and wrap the set of threads that you just added the washer to, starting at the washer and try to make the teflon cover the the gap between the center of the washer and the fitting, sort of like an L, and continue down the threads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |